![]() ![]() You are tightening a metal nut against the shaft which tightens the internal collet that keeps the machine in place ready to cut the ferrule into the cue dowel. In this case, this handy tool enables you to quickly prepare a cue without the need for expensive machinery which means it can be completed at home.Īn additional collet (cue diameter guide) can be purchased from the main stockist to enable cue tips from 11mm to 15mm.Īs an additional note, we would add that it would be good practice to ensure you protect your shaft with an appropriate tape when tightening the Tweeten Cue Tip Ferrule Cutter (Tweeten Tenoning Machine) to ensure you don’t damage the cue shaft surface. Much of the physics of the Player Series Acoustasonic Telecaster are just that, finding the happy medium between electric and acoustic design. Normally ferrules are fitted by the use of a lathe. ![]() This is a very simple to use tool which lets you cut the cue neatly ready to take a ferrule. The ferrule cutter will take shaft tips between 6.5mm and 10.4mm in diameter. These cue tips are crafted from special tanned leather which allows for excellent chalk retention and decreases the amount of mushrooming that may occur. ![]() Tweeten Cue Tip Ferrule Cutter (Tweeten Tenoning Machine). The cue should slide easily into position, if it doesn’t then please re-read the information supplied or advice should be sought.” Tool Description If adequate protection of the shaft isn’t taken, over tightening of the machine, incorrect collet used, forcing cues in the machine are experienced then there is a possibility of cue damage. This item: Tweeten Rapid Cue Top Sander Repair Billiard Pool Stick Tip. “Snooker Crazy do not take any responsibility for damage to cues when using this machine. The Tweeten Tenoning machine cuts wood from the cue, not metal, and yes, people have tried!” The Tweeten Home Repair Kit contains cement, cue tips, a tip clamp, cue top sander, scuffer, chalk, and table spots. In no way does it cut metal ferrules off of an existing cue, you will need to remove the ferrules by the conventional method. Before we give a description we would just like to ensure you understand that this tool when correctly described is a ‘Tenoning machine’ made by Tweeten. Please read these points and the tool description before deciding to purchase the tool. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |